Pressure washing walk- and driveways

Walk- & Driveways

Get 10% OFF
Your First Walk- & Driveways Cleaning Service!
Reliable and Quality Pressure Washing Service for your Home in Clearwater and the Tampa Bay area.

We are FULLY LICENSED AND INSURED!
We keep our promises! We are on time or keep you updated, if we are running late!
We guarantee 100% customer satisfaction!

Pressure Washing Walk- & Driveways in Tampa Bay

The front of your home is the first thing a visitor or potential buyer will see when they drive up to your house. It is not difficult to understand, why this outdoor space might need your first attention to make a good impression.

Heavily used and often neglected

Walk- and driveways get used a lot and are liable to becoming stained by cars and soiled by normal daily use.

Grease, Oil, grime and dirt can all be safely removed by pressure washing. While simply hosing the area down will only push any loose debris and surface dirt to the side - it will not remove obstinate stains nor restore that fresh, clean look your walk- and driveway once had. No need to put up with this!

Try pressure washing for an amazing, clean look. You will get great results by following some basic rules. (See below)

Before pressure washing

After pressure washing

Different types of surfaces

Every surface can be pressure cleaned and will make your property literally look like new. The above and the photos below should have given you already quite a good idea of how your walk- or driveways could look like. However, we also collected a number of short videos and written some articles to show you the different surface types and what pressure washing can do to rejuvenate them. Scroll down to watch the educational videos on cleaning concrete and especially some on cleaning bricks.

Driveway before pressure washing by DPI Pressure Washing & Window Cleaning LLC

Paver driveway before pressure washing by DPI Pressure Washing & Window Cleaning LLC

Driveway after pressure washing by DPI Pressure Washing & Window Cleaning LLC

Paver driveway after pressure washing by DPI Pressure Washing & Window Cleaning LLC

Pressure washing brick-walkways, walls and stairs

Brick has been popular by homebuilders but isn't used as much any more these days. However, there are many mostly older homes, that still have that classic look of brick. Over time, dirt, grime and moss can cause discoloration and thus cover the natural red look. Low pressure washing is a quick way to restore your bricks to their former beauty.

Before you start the cleaning or your bricks, patch damaged mortar, and allow it to dry for at least a week. If your house has brick walls, you should remove obstacles nearby, cover plants and electrical components and close windows and doors before starting the job.

Tips for Pressure Washing Brick:

Brick is porous and dry and therefore absorbs quickly, so before you apply detergents, thoroughly soak the surface of your bricks with clear water. Since you only want to clean the face of your bricks, wetting them will prevent the cleaning solution from soaking into the whole brick. Go over the area several times and make sure it's thoroughly soaked. Use a delicate, low-pressure spray pattern before you start applying the cleaning detergent.
Apply detergent from the bottom to the top, and allow it to soak for five to ten minutes. Make sure to keep the bricks wet as needed if any areas begin to dry out.
Use low pressure and more detergent if needed, to get your brick really clean.
Ideally you should use a rotating scrub brush and scour areas that are heavily soiled. (Watch the short videos below.)
Rinse the detergent and residue from the top to the bottom with a low-pressure, delicate spray pattern. You might have to go over some areas several times to clean deep stains completely. When you’re done cleaning, you can seal your bricks with a brick and mortar sealer by following the manufacturer’s instructions.

Video Section:

Pressure-scrubbing a brick-walkway. The dirt comes off nicely :-)
Length: 0:17 min.

How-To Video: Pressure washing a brick-paver drive- walkway:
Length: 1:14 min., Views: 32,150

Note, that in none of the videos above, they soak the bricks. I would always recommend wetting them thoroughly. Only exemption might be, when you don't use any detergent but pressure wash with water only.

I also found the following, very educational video on the subject of brick masonry cleaning:
Length: 4.17 min., Views: 3.338

How-To Video: Pressure washing a concrete walk- and driveway by the ehow.com pro:
Length: 2 min.

Cleaning a Walkway With a Pressure Washer —powered by eHow.com

Give this often neglected space the attention it deserves to make your home “shine”!

PressureWashingClearwater.com is a local, family-owned business that is expanding. Our friendly team is fully licensed & insured and equipped with state-of-the-art tools to take care of your business.

Questions? Need a Quote? Call NOW - 24/7: 1-813-991-7243

Looking forward to hear from you,

Mauricio Munoz
Owner, Pressure Washing Clearwater
Email Me

As a recommendation:

Getting the help of an experienced pressure cleaning company will save you the time and headache of possibly damaging your roof or deck by doing it yourself.

Try our professional pressure washing services and get your FREE Pressure Washing Quote today, or call now our Clearwater office Toll-Free 24/7: 1-813-991-7243

We are FULLY LICENSED AND INSURED!
We keep our promises!
We are on time or keep you updated, if we are running late!
We guarantee 100% customer satisfaction!

TIPS: How To Keep Your Cleaned Surfaces Clean!

Cleaning with DPI Pressure Washing Clearwater

Although we'd like to service you year-round, we feel that with a little help, you can enjoy your clean outdoors much longer!

Learn how to maintain your pressure-washed deck, roof, sidewalk, pool screen and more.

Get Professional Tips to Avoid Unnecessary Expenses.

Pressure washing care tips

how to articles

how to videos

whitepapers